The running-in period of the underground loader is so important!

Everyone is familiar with the running-in period. New cars need to go through the running-in period. As a mining vehicle, the underground loader also needs to go through the special stage of the running-in period. The run-in period is an important link to ensure the normal operation of the underground loader, reduce the failure rate, and extend the service life. It can be seen that the run-in period of the underground loader is very important! In addition to understanding that the running-in period of underground loader is very important, we should also master the precautions for the running-in period of underground loader:

(1) Due to the particularity of the loader, the operator should have received professional training from the manufacturer, have sufficient knowledge and understanding of the layout and function of the machine, and obtain certain operation and maintenance experience before operating the machine.

(2) Pay attention to the operating load during the running-in period. The operating load during the running-in period should usually not exceed 60% of the additional operating load, and the appropriate workload should be arranged to avoid overheating caused by long-term continuous work of the machine.

(3) You should also pay attention to often check the oil, hydraulic oil, coolant, brake fluid and fuel oil level and quality, and pay attention to the seal of the whole machine. It is found that there is too much oil and water in the inspection, and the reason should be analyzed. At the same time, the lubrication of each lubrication point should be strengthened. It is recommended to add grease to the lubrication point during the running-in period, except for those with special requirements. Busy at both ends, telescopic loaders, underground loaders

In addition, in order to better pass the running-in period of the underground loader, the machine should be cleaned frequently, and the loose parts should be adjusted and tightened in time to prevent the loose parts from aggravating the wear of the parts or causing the loss of the parts.